TECHNOSOFT presents the new family of iPOS-Z drives. With a dedicated CPU designed for motion control applications using EtherCAT communication, the iPOS-Z drives support as well CAN, USB and RS232. Having nominal currents of 10A and 15A rms at 48V and 80V, these drives will control motors up to 750w for the plug-in/connectorized versions [...]
The Technosoft team will be present at SIDO the 22nd and 23rd September 2021 at the Centre de Congrès, Cité Internationale in Lyon. We invite you to visit our stand no E313 where you will have the occasion to see the newest Technosoft products and discuss with our specialists about the requirements [...]
We invite you to visit our stand no E-13 in Hall 3 at the SINDEX Fair in Bern (31st August to 2nd September) where you will have the occasion to see the newest Technosoft products and discuss with our specialists about the requirements of your motion control applications. Request your free exhibition [...]
A dedicated programming language helps implement complex control concepts Numerous applications in different fields require compact drives in order to carry out precisely defined axis movements in sequence or in parallel. This interaction is usually coordinated via a master unit, which gives the individual motors appropriate commands. However, it is necessary to align [...]
Join us March 22-26 for Automate Forward 2021 virtual trade show! Exhibiting in a virtual environment has its challenges but we don't want to miss this opportunity to meet, chat, and show you our latest technology just as we would have in person. Registration is FREE! See you soon! Visit Technosoft at [...]
This application note describes how to implement a homing routine, using a function that aligns the load to the middle of the working area. The homing procedure follows the algorithm below: move negative until the negative limit switch is reached; stop and set the current position to 0 [IU]; move positive until the positive limit [...]
The homing methods are special functions used to align the load with a known position. This is necessary in case of the applications where the motion is restricted and the system is not equipped with an absolute position sensor. This application note describes how to use the homing methods predefined in Easy Motion Studio and [...]
This application note describes the available start modes. The start modes are special procedures required to align the magnetic fields in the motor. Start modes description The preferred start mode can be selected during the setup phase, trough the “Drive Setup” dialogue. Figure 1. Start mode selection Depending on the system configuration (drive model, [...]
Samples of "Opération Soyons Solidaires" in the Media
On March 13th, MOONS' Electric, (hereafter referred to as MOONS'), acquired 100% of the share capital of Technosoft Motion, which became a wholly owned subsidiary of MOONS'. MOONS' is a worldwide leading manufacturer of motion products. With the culture of "Closer to Customers". MOONS' has continuously worked on creating and upgrading its operating network to [...]
