11 08, 2018

Possible causes of the communication failure between PC and Technosoft drives [GB]

2018-09-08T21:28:10+00:00

Below are presented the most frequent causes for communication errors reported by EasyMotion Studio: 1. Communication port is not working properly. > Solution: Check the communication port settings. 2. Drive gets reset by the power supply voltage drop. This situation can appear if the same power supply is used to for the logic and the motor stage of the drive. If the current demanded [...]

Possible causes of the communication failure between PC and Technosoft drives [GB]2018-09-08T21:28:10+00:00
11 08, 2018

How to determine the axis ID of a drive connected over RS232 [GB/CM]

2020-10-27T09:55:53+00:00

EasyMotion Studio and EasySetUp are able to automatically determine the axis ID of the drive connected to the PC via RS232. This feature is enabled when the Axis ID of drive/motor connected to PC option from Communication Setupdialog is set to autodetect.    Communication Setup dialog for EasyMotion Studio Communication Setup dialog for EasySetUp Once it is configured for autodetect, EasyMotion Studio/EasySetUp will determine [...]

How to determine the axis ID of a drive connected over RS232 [GB/CM]2020-10-27T09:55:53+00:00