3 04, 2023

RS-232 communication from a terminal (RealTerm)/ master

2023-04-03T13:58:07+00:00

RS-232 communication from a terminal (RealTerm)/ master All the Technosoft servo drives or intelligent motors can communicate via the RS-232 protocol. This is a point-to-point, full duplex communication, allowing simultaneous transmission in both directions.The Technosoft drives and motors communicate serially using 8 data bits, 2 stop bits, no parity at the following baud rates: 9600 [...]

RS-232 communication from a terminal (RealTerm)/ master2023-04-03T13:58:07+00:00
11 08, 2018

RS232 protocol on Technosoft drives

2024-05-27T15:06:42+00:00

All Technosoft drives use the following settings for the RS232 communication: 8 data bits, 2 stop bits, no parity and no flow control. The RS-232 protocol is full duplex, allowing simultaneous transmission in both directions. After power on or reset, the default baud rate is set to 9600bps. Once the communication between the host and the [...]

RS232 protocol on Technosoft drives2024-05-27T15:06:42+00:00